HERZ ETKF+
Page 11
Screw mounting:
• Choose a site for installation.
Make sure that no electricity or similar lines run in the wall at this location.
• Position the mounting plate on the desired site on the wall. Make sure that the arrow on the
mounting plate is pointing upwards.
• Use a pen to mark the positions of 2 bore holes (1) (diagonally opposite) in the mounting plate on
the wall. The bore holes (2) can be used for installation with a flush mounting box.
• Now drill the bore holes. If you are working with a stone wall, drill the marked two 5 mm holes and
insert the plugs supplied. If you are working with a wooden wall, you can pre-drill 1.5 mm holes to
make screws easier to insert.
• Now drill the bore holes. If you are working with a stone
wall, drill the marked two 5 mm holes and insert the
plugs supplied. (If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws easier to
insert).
• Use the screws and plugs supplied to fasten the
mounting plate to the wall.
• Attach the electronic unit with the frame on the mounting
plate. Make sure that the arrows on the back side of the
electronic unit point upwards and that the clips on the
mounting plate latch into the openings on the electronic
unit.
