Page 5
HERZ Wireless control system
First installation
This section will guide you through the set up of your thermostat for the first time.
Batteries installation
• Open the two side covers and insert the 2 AAA alkaline supplied batteries (or remove the small protection
sticker, if the batteries are already installed in the compartment)
• Close the two side covers.
• Now your thermostat will propose you to adjust the current time and date.
Time and date adjustment
Each time a value flashes, you can adjust it with the
(-)
and
(+)
keys, once the value is chosen, confirm it with the
(OK)
key. The thermostat will jump automatically to the next value.
Note:
You can always come back to the previous value by pressing the escape key ( ).
List of the order time and date adjustments
Time and day:
Adjustment of the hours
Adjustment of the minutes
Adjustment of the day (1 = Monday)
Date:
Adjustment of the day number
Adjustment of the month number (01 to 12)
Adjustment of the year
When the message
“Save”
and the blinking green LED appears, press
(OK)
to confirm the adjusted time and date.
You can always reach the time and date adjustment, by pressing and maintaining the edition key during 2 seconds
in normal operating modes.
RF installation
First of all to configure your thermostat with the receiver, you must put your receiver in the
« rF init »
. mode. (Please refer
to the receiver leaflet for this, only the RF receiver of the same range are compatibles). Now on the thermostat press and
maintain the edition key ( ) during 5s, then the parameter
« rF ini »
must be displayed.
The thermostat will send now the radio configuration signal to the receiver. After few seconds the thermostat and
receiver should exit by the
« rF ini »
mode, this is the normal procedure to confirm a correct pairing.
