MD2 WIRED THERMOSTAT
Program Mode
The MD2 has a 7 x 1 day timer (Monday to Sunday) with 4 periods per day. For example, you could choose
Period 1 to be the temperature you wake-up to; Period 2 the daytime set-back temperature; Period 3 the late
afternoon / early evening temperature and Period 4 the nighttime setback temperature.
Unlike conventional heating, Herschel Far infrared directly heats the room (the “Thermal Mass”). For areas in
frequent use it is more economical to avoid temperatures dropping too low as the heater will need to be on for
a much longer period to restore temperatures. We recommend overnight setback temperatures of no lower
than 14°C and daytime temperatures of 16°C and above. Always try to program the schedule so a room is at
the temperature you want by the time you want. For example if you want it to be 21°C by 0700 am, consider
starting the program at 0600 a.m.
To set the 7 days program
•
Press
for 3 seconds to start the 7 x 1 day program setting. The First period of the First day is
selected.
•
Press
or
to set the time of the first period of the day’s program.
•
Press
and
to select the desired temperature setpoint.
•
Press
again to proceed to the next period.
•
Repeat the above procedure for each period of each day.
The default settings you will receive with your MD2 are as follows:
To select Program Mode press
until
is displayed as the mode.
The schedule will then operate until another mode is selected.
All Days
Period 1
0630 21
℃
Period 2
0800 18
℃
Period 3
18:00 21
℃
Period 4
22:30 16
℃
