î
Turn the adjusting nut (2) to position stop
lamp switch at a point where the stop lamp
will glow just before the brake pedal is
depressed to the limit of its free play. Turn the
adjusting nut in direction (A) to advance
switch timing or in direction (B) to retard
switch timing.
Stop lamp switch
The stop lamp switch (1) must be adjusted so
that stop lamp will glow when rear brake is
applied. Rear brake pedal free play
(page
39)
should be adjusted before performing
stop lamp switch adjustment. The procedure
for adjusting stop lamp switch is as follows :
î
Turn the ignition switch is to “ON” position.
42
î
Disconnect the negative (-) terminal lead
from the battery first, then disconnect the
positive (+) terminal lead.
î
Pullout the battery from the battery box.
Battery installation
î
Reinstall in the reverse order of removal. Be
sure to connect the positive (+) terminal
first, then the negative (-) terminal.
î
Check all bolts and other fasteners are
secure.
Fuse Box
(1)
:
Location : Mounted on the
battery clamp (2).
Fuse replacement
Fuse Holder
(5) Location : Over the solenoid
switch adjacent to battery.
The specified fuse is 20 A (6) with a spare fuse
20 A (7).
The specified fuse is 15 A (3) with a spare fuse
15 A (4).
2
7
5
6
3 4
1
CAUTION
!
!
î
Turn the ignition switch "OFF" before
checking or replacing the fuse to prevent
accidental short-circuiting.
î
Do not attempt to start or ride the
motorcycle without a charged battery, it can
cause fusing of the bulbs and permanent
damage to certain electrical components.
WARNING
!
!
î
Battery gives off explosive gases. Keep
sparks, flames & cigarettes away.
î
Never use a fuse with a different rating from
that specified. It may lead to serious damage
to the electrical system or a fire due to short
circuit.