Installation – Bath Filler / Bath Shower Mixer Cont.
* Bath shower mixer only
1. Identify all components are present prior to starting installation.
2. Connect the elbow assembly (5) to the tap body, then connect the pillar assembley (6) to the
elbow (5).
3. Using the washer (7) and backnuts (8) secure the pillars to the bath by tightening the backnuts
onto the pre-fitted threaded tails. A suitable spanner may be required to fully tighten the
backnuts (8).
4. * Attach the cradle assembly (3) to the tap body, again ensuring the washers are correctly
placed.
5. * Fit the handset (1) to the shower hose (2) and connect the hose to the outlet on the cradle.
6. Connect the hot and cold water supplies.
7. Turn on the water and fully open the mixer, allowing it to run for a few minutes and check all
joints and connections for any leaks.
8. * To fit the wall bracket, ensure firstly that the position will allow the handset to comfortably
reach it when attached to the 1.5m hose. Mark out and drill the hole to suit the rawl plug (12).
Using the screw (10), fit the shroud (11) to the wall and assemble the remaining components as
shown in the diagram.
Wall Mount Installation
To wall mount this product, unscrew the elbows from the body and screw the legs directly into the
rear inlets of the tap body.
NOTE:
This will alter how far out the product will sit proud of the wall. Care must be taken
when attaching the product, Please do not place weight on this product when fitting
as a wall mounted option.
07
