Pag.4
1.6 Operation (Remote Control)
Igniting the flame
*
Open the gas shut-off cock that has been installed in the gas pipe to the unit.
*
Press the “
O I
” switch on the gas control block to the “
I
” position.
*
Turn the operating button on the gas control block into the
ON
position.
*
Press the
OFF
and
(large) switches on the remote control at the same time. A short sound signal will con-
firm commencement.
Short sound signals will then follow until the pilot light and main burner are ignited.
Once the main burner is ignited, the flame will adjust to its maximum height automatically.
1.7 Possible error messages
*
Long sound signals during ignition: Receiver batteries are almost empty. (After this signal is heard, the unit may be
switched on approximately 10x more).
*
5 seconds of continuous sound signal: Error message. For example: one of the cables is not connected, the “
O I
”
switch is not in the “
I
” position.
*
5x short sound signal: The pilot light or main burner are not ignited.
Possible cause: air in the pilot pipes.
Piëzo Ignitter
(Manual)
Manual knob
Main valve knob
Microswitch
“
O I
” Switch
8 Wire Receiver Jack
Combination Control, Cover
If the pilot light is extinguished, wait at least 5 minutes before
repeating the steps above.
NOTICE
