17
ADJUSTING THE HEIGHT OF HANDLE(H36GC16C)
WARNING:
Do not attempt to start the mower until the handle has been
locked at one of the three preset operating positions(lower/middle/higher).
LOCKED STORAGE POSITION: Your mower is shipped with the handle in the
compact, locked position (Fig. 1).
EXTEND THE SIDE RAILS: move the side rails to the back of mower, release
the handle-locking clamps(see Fig.3) and then fully extend the upper side rails
by stretching them out (see Fig.2) before any operation.
ADJUSTING THE HEIGHT OF HANDLE: loosen the two lower quick-adjustment
levers by turning them in counterclockwise; LOWER OPERATING POSITION:
adjust the angle between side rails and the ground by hand until the arrow (see
Fig.2 in previous page)points to the 1st calibration tail(see Fig.2 in previous
page)(the angle is approximately 41 degree),tighten the two quick-adjustment
levers by turning them in clockwise; MIDDLE OPERATING POSITION: adjust
the angle between side rails and the ground by hand until the arrow (see Fig.2 in
previous page)points to the 2nd calibration tail(see Fig.2 in previous page)(the angle is approximately 50
degree),tighten the two quick- adjustment levers by turning them in clockwise; UPPER OPERATING POSITION: adjust the angle
between side rails and the ground by hand until the arrow(see Fig.2 in previous page) points to the 3rd calibration tail(see Fig.2 in
previous page)(the angle is approximately 59 degree),tighten the two quick-adjustment levers by turning them in clockwise.
NOTE:
The motor cannot be started unless:
a. The side rails are fully extended
b. Both green handle-locking clamps are securely closed
c.
The handle is locked into one of the three operating positions
ATTACHING/REMOVING THE GRASS BAG
WARNING:
Do not at any time make any adjustment to the lawn mower
without first stopping the motor, removing the battery pack and waiting for the
blade to stop rotating.
NOTICE:
Remove the side discharge chute before attaching the grass bag on
the mower;
1. Remove the battery.
2. Lift the rear discharge door up.
3. Hang the grass bag assembly on the hook (Fig. 4). Release the discharge door so that it rests on the grass bag.
4. To remove the grass bag, lift the rear-discharge door up. Lift the grass bag off the hook.
5.
Release the rear discharge door.
WARNING:
When using the grass bag, never operate the mower unless the grass bag are firmly seated on the hooks and
the rear-discharge door rests firmly against the top of the grass bag.
WARNING:
Under normal usage, bag material is subject to wear. To reduce the risk of injury, frequently inspect the bag
assembly and replace if there are any signs of wear or deterioration. Use only grass bags manufactured for this mower.
1
2
3
4
hooks
