Henny Penny SmartCombi ESC-220, Руководство по устранению неисправностей

Страница: 36 / 44

Smart Combi™ Service
Troubleshooting for WaveClean 6.x - 20.x
First of all ensure that no mistakes has been done from the operators side.
Furthermore make sure that there has paid attention on the right storage of the cartridges and
the wax layer in the cartridge has not been damaged before.
Storage notes:
–
Protect cartridges against direct sunlight or heat sources.
–
Do not place cartridges on hot surfaces.
–
Do not store cartridges in a car for longer time (especially during summer).
If you can not ensure that the cartridges has been stored correct use new ones from your own stock.
Situation: The cartridge gets melted
–
Ensure that the cartridge placed in the holder after the displays shows „insert cartridge“. If the
chamber temp. is to hot the unit cools down itself.
–
Check if both water connections are connected and that water is available
–
Check if the water inlet filters in the water assemblies are free of dirt.
–
The cartridge has not removed after the cleaning cycle.
Situation: Residues of cleaner/rinser remain in the cartridge or cartridge is not properly
emptied, the chamber did not clean the chamber and/or has white deposits.
No error message came up during WaveClean (Check diagnosis memory).
–
Ensure that the oven is in level and that both water assemblies are connected.
–
The cartridge holder could be bent. Bend the cartridge holder into position (Only 6.x, 10 . x):
–
Carry out the WaveClean Test in the configuration menu for a functional test and ensure that the
door gasket area is tighten, both pumps as well as the solenoid valve which fills the trap
quenching box) with water are working. Use the relay test to check the components separate, if
necessary.
–
Check if the water inlet filters in the water assemblies are free of dirt.
–
During WaveClean the water flow pressure dropped down less than 1,5bar.
–
Heating element or solid state relay defect.
–
During operating too much lime quantities has been built up which could not be dismantled by
WaveClean.
36
Bend the end of the cartridge holder with a plier upwards
until the cartridge rests in horizontal position when inserted
into the holder. Hold the holder with another plier on the
other side duiring the bending operation