Henny Penny EVOLUTION ELITE EEE-181, Техническое руководство

Страница: 57 / 118

Model EEE-182
6-15
Each vat has a solenoid plumbed-into the oil return lines. They
are normally closed, but open when power is supplied, such as,
the controls are filling the vats.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel and hinge it down.
2. Referring to the decal on the rear of the control panel, locate
P3 connector (left vat-split vat) or P4 connector (full or right
vat).
3. Pull the connector from the panel and using a multimeter,
take an ohm reading on the appropriate pins. If ohm read-
ing is significantly different than the chart below, continue
with replacement instructions.
120Volts-60Hertz 50 Ohms
220-240Volts-50Hertz 230 Ohms
Replacement
1. Remove the rear panel (9 screws).
2. Remove the plastic retaining clip on top of the coil housing.
3. Push-down and then lift-up on name-plate and remove the
name-plate, cover and coil housing from solenoid stem.
4. Using a 1” wrench, loosen the fitting on the right side of the
solenoid.
6-12. SOLENOID VALVES
July 2016