Henley Stoves BIO 80, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 33

BIO Pellet Stoves
13
Control panel
Pic. 11
Key (P1+) and (P2-): they increase or decrease the thermostat parameter from minimum 06°C to
maximum 40°C. If you keep (P1) pressed you can see the waste fumes temperature displayed. They
both have programming function.
Key (P3): to go to menu of parameters of the user and technician.
Key (P4): (ON/OFF) to turn on and off, to unlock from alarms and go out from programming.
Key (P5-) and (P6+): to increase or decrease the power/ventilation of the stove from 1 to 5.
Led1
if on, it indicates programming timer active.
Led2 if on, it indicates the cochlea is working.
Led3 it flashes when receiving input from the remote control.
Led4 if on, it indicates that the chosen temperature is reached.
Led5 it flashes when you are setting temperature, or you are inside the menu.
Led6 if on, it indicates active glow plug.
Led7 if on, it indicates active alarm.
Display A: during start-up phase it shows the state of the stove. During the functioning it shows the
heating power. When setting input, it shows the parameter label you are changing.
Display B: during start-up phase it shows the state of the stove. During functioning it shows the
temperature chosen by the user. During input setting, it shows the parameter you are changing.
Starting
To start the stove, keep key (P4) pressed for few seconds, then the gear case will set the stove in a pre-
ventilation state, displaying “Start”, starting the extractor fan at minimum rate and the pre-heating of the
starting resistance. After this phase which lasts 2 minutes, it will be displayed “Load Pellet”, the cochlea
will stoke pellets and the resistance will keep warming up. When the temperature is high enough, thanks
to the fume gas feeler, the electronic gear case (after 7-10 minutes) will consider the starting phase
ended and start the next phase of flame stabilisation displaying “Flame light” and starting the tangential
ventilator (heat exchanger). When the “Flame light” phase ends, the gear case will set the work state,
displaying the chosen heating power (you can change it with keys (P5-) and (P6+) and the environment
temperature. During this phase keys (P5-) and (P6+) can regulate the stove power from 1 to 5. If the
environment temperature exceeds the limit parameter fixed on keyboard during the temperature
setting the heating power will decrease to minimum rate until the parameter is back to its prefixed limit.