Henkel Loctite 135550, Руководство по эксплуатации

Страница: 12 / 40

12
5 Dispensing
5.1.2 Adjusting the Dispensed Quantity
5.1.2.1 Time Controlled Mode
This mode of operation is used for spot shaped wetting or drop dispensing.
● With buttons or set the dispensing
time to 0.50 s (factory setting). The
indication of the dispensing time in the
digital display begins blinking.
● With the pressure regulator
8 set the
dispensing pressure to 0.50 bar (approx.
7 psi). An error message „
Press. 0.83
NOK
“ with beeping is possible. The
value 0.83 [bar/psi] is only an example
for the indicated dispensing pressure
(see Chapter 7).
● Press button to store the dispensing
pressure setting as the comparison
value for automatic pressure monitoring.
The error message with beeping is
eliminated.
● Press the Footswitch
15 to check the
dispensed quantity.
If the dispensed quantity is too small:
● Increase the dispensing pressure and store. Check the dispensed quantity again.
Repeat this sequence until the desired dispensed quantity is roughly achieved.
When the desired dispensed quantity is roughly achieved:
● Set the exact dispensed quantity by changing the dispensing time with button or .
● Press the Footswitch
15 to check the dispensed quantity.
Storing of the dispensed quantity setting for subsequent dispensings:
● Press button . The indication of the dispensing time in the digital display stops
blinking.
If the desired dispensed quantity is not achieved:
● With a larger (or smaller) dispensing needle, repeat the steps of Section 5.1.2.1.