Hengmei PJMP2113, Руководство по эксплуатации

Страница: 18 / 52

Tel: +86-18615559369 Web
:
www.pellet-machine-mill.co m
E-mail: lingfengzhuri@gmail.com
- 13 -
PJMP215
≤86.5 ≤10.5
PJMP216
≤110 ≤12
PJMP218
≤200 ≤16
PJMP2113
≤420 ≤23
2. When tighten the blade, please make sure to use the torsional spanner which can concretely show the
torsional spanner and increased torsional equipment (along with this machine).
3. When tighten the fixed blade, please make sure to use the torsional spanner which can concretely show
the torsional moment.
4. The tightening bolts of the rotary blades and fixed blades must be adopt the special high-strong bolts
supplied by us ( which top of bolt shows the ZL). DOONOT use the common bolts. The lifetime of
high-strong bolt is one year, PLEASE change all by new ones after one year.
5. The rotary blade change must be in sets. When sharpening the blade edge, two rotary blades sharpeded
qutity should be the same, make sure the weight of two blade is consistent, avoid unnecessarily shaking.
When deliver ied, two rotary blades have been matched already. If found blades confused, please weight
and match them again. Please pay more attention to each set of rotary blades, make sure the different
weight between these two blades less than 25 gram.
6. When the rotary blades and fixed blades sharpening, pelase add the refrigerant, otherwise the blade
edges will be wicked because of too hot or curled, causeing the durability of blade reduced. Generally
speaking, the rotary blades should sharped every one or two shift. After rotary blades changed four times,
please take out the fixed blade and do these two things: check the fixed blades if necessary to change the
cutting edge; Lubricate contact surface of fixed blade base.
7. When the nitrogen pressure in accumulator is lower than the regulated value in Table 8, please fill the
nitrogen. Please check the pressure and air filled by the aerated tool.
Note: Please aerate the nitrogen to accumulator, DONNOT aerate the oxygen or air, otherwise will lead
to explode . Details should be acted according to the description of manufacturer. When aerating the
nitrogen by the nitrogen bottle directly, the switch should open slowly, prevent the high-pressure nitrogen
enter into bottle and damage gallbladder.
8. Electric apparatus should be checked termly, make sure the correct action of them, avoid the
unnecessary damage.
9.When the machine chips overload, the operation current should not surpass the rated current (the
instantaneous overloading is permitted).