Pressure Transmitters 050D series
Operating Instructions
- English - V1.0
PN-TI118-EN-14-1/6
Hengesbach GmbH & Co. KG
·
Schimmelbuschstr. 17
·
40699 Erkrath
·
Tel. +49 (0) 21 04 / 30 32-0
·
Fax +49 (0) 21 04 / 30 32-22
·
www.hengesbach.com
3
Important notes
3.1
Intended use
The pressure transmitters of the 050D series are designed for measuring the process pressure of aggressive and non-aggressive gases,
vapours and fluids. Depending on the construction of the device, the transmitter can be used for measuring both absolute and relative
pressures.
The manufacturer cannot assume any liability for damage due to any other kind of use or the incorrect use of the
devices. If in doubt, please contact the manufacturer with regard to the suitability of the device for your specific
application before its installation.
The device is not intended for operation in an explosive atmosphere.
Please read these operating instructions carefully before commissioning the devices. If you have questions, please contact the
manufacturer's technical department.
The manufacturer can be contacted under the following address:
Hengesbach Prozessmesstechnik GmbH & Co. KG
Schimmelbuschstr. 17
40699 Erkrath
GERMANY
Tel.: +49 (0) 2104 3032 – 0
Fax: +49 (0) 2104 3032 – 22
3.2
Assembly, commissioning and operation of the device
The transmitter has been manufactured according to state-of-the-art technical knowledge and complies with all relevant guidelines for it to
be safely operated.
The assembly, connection, commissioning, operation and service of the device should always be carried out by qualified personnel.
Personnel who are carrying out the above tasks must have been authorised by the plant operator.
This document is to be kept in a location accessible to all the persons who need it. A further copy is available from the manufacturer or can
be downloaded from their homepage.
