ONDA Series
Quick-Mount Hi-Fi Coaxial In-Wall/In-Ceiling Speakers
8
ones shown on “4. PRODUCT APPEARANCE” at page 5
4. Carefully cut the hole with the appropriate cutting tool for your wall or ceiling
material. Start the hole by drilling a hole on the inside of the tracing (with the
drill bit touching the line). Use this hole to insert the saw or knife and begin
cutting.
5. Remove the magnetic speaker grille.
6.
Once you have cut the hole, fish your previously positioned wiring out of the
hole and connect the speaker. Strip about 2” (12 mm) of insulation from each of
the two conductors of the wire to expose the bare metal and twist each of the
conductors into a single unfrayed strand (so you have two unfrayed strands).
Note that one of the two terminals on the rear of each speaker is red (+) and
the other is black(-). Make certain that you connect the wire from the red ter
-
minal (+) of your amplifier or receiver to the red terminal (+) of your speaker,
and the wire from the black terminal (-) of your amplifier to the black termi
-