OPERATION MODE
Current mode is displayed in the middle of bottom line of display under “HEATING MODE” section.
The thermostat has 4 operating modes:
GEN – general (comfort) mode. Recommended normal comfort.
ECO – economy mode. Power efficient saving.
DRY – fast floor drying.
OFF – manual mode. The thermostat logic is disabled and mode display is blank.
Change the mode by touching the MODE key and reselecting as above.
Each mode has its own settings for maximum and minimum temperature.
The thermostat will operate automatically depending on the current set point. To change the set point values
choose the desired mode and press “+” key to increase or press “-” key to reduce the value. Alternatively
control from your Z-wave gateway.
The three operating modes have individual temperature set points which operate automatically depending on
the settings.
In the OFF mode the thermostat heating state can be switched manually by pressing the “HEATING” key.
Note: if the OFF mode is enabled nothing will be displayed in the HEATING MODE section and the SET POINT
will indicate OFF.
GEN (comfortable) MODE
This mode is recommended for normal comfort.
Factory default set point is 25.0°C (77°F)
Minimum set point is 4.0°C (39°F)
Maximum set point is 37.0°C (99°F)
ECO (energy saving) MODE
You can use this mode if lower temperature and energy consumption is required. It can also be used at night
or when absent from all or part of the property for a length of time.
Factory default set point is 18.0°C (64°F)
Minimum set point is 4.0°C (39°F)
Maximum set point is 37.0°C (99°F)
DRY MODE
This mode is recommended for use if a high floor temperature is required for a limited period of time for
example after floor washing. By choosing DRY mode the thermostat will increase the temperature to the
selected set point for a limited time specified in the “Dry Time” Parameter. The time range of 5-90 minutes
can be selected. After the drying time the thermostat will automatically change back to GEN mode.
To change the Dry Time, go to “Settings Mode” by pressing the “MODE” key for 3 seconds. Use the keys
“HEATING” or “MODE” to scroll the menu to Parameter 09, then use keys “+” and “-” to increase or reduce
the time. The value of Dry Time is in minutes.
Factory default Dry time is 30 min.
Factory default set point is 30.0°C (86°F)
Minimum set point is 4.0°C (39°F)
Maximum set point is 37.0°C (99°F)
