Helpmation JP-C1H, Руководство пользователя

Страница: 38 / 43

9
HOW TO OPERATE
IMPORTANT: MUST READ ALL OPERATING INSTRUCTIONS PRIOR TO FIRST USE.
POWER SWITCH
Before first use let battery fully charge.
1. Switch to position II – battery operation.
2. Switch to position I – operation from cigarette lighter
3. Switch to position 0 – washer is switched off
IMPORTANT:
DISCONNECT THE POWER CABLE WHENEVER ENGINE IS TURNED OFF FOR EXTENDED PERIODS OF TIME. THE
POWER DOES NOT TURN OFF AFTER SWITCHING OFF THE ENGINE IN SOME CARS. IF THE POWER PLUG IS LEFT
CONNECTED, THE BATTERY MAY BECOME RUN DOWN OR DAMAGED
Plug into car cigarette lighter
Open the cover on the bottom of the dishwasher and
connect the power cord connector to the dishwasher
body. Take the car adapter out of the dishwasher and
close the cover door. Plug the car connector into the
cigarette lighter. Switch the dishwasher to the
position I. with power switch.
PURGE AIR FROM SYSTEM
To purge air, turn unit on (Diagram2). Point nozzle into water tank and squeeze
lever until steady stream of water exits hose (Diagram 2a)
With normal use, air can get trapped in the hose. We recommend the following
steps to purge the air out of your system and get the maximum amount of
pressure out of your new car washer.
FOLLOW THESE STEPS AFTER EACH TIME YOU REFILL YOUR TANNK:
1. Fill the tank with water.
2. Connect the hose to the unit.
3. Connect the power cord to the unit.
4. Direct the hose. Without the nozzle attached, into the tank.
5. Turn the power on and run for approximately 30 seconds or until a steady stream of water is present.
6. Turn off the power.
7. Connect the nozzle to the hose.
NOTE: Please start the engine while using the device if you are not sure whether the capacity of the Car
Battery is sufficient or not
.