26
Connecting the electricity is the most important part of the installation of a sauna heater.
Only certified electricians may install the sauna heater. The heater should be connected
half-fasten to the electricity network. You must use a standard cable HO7RN-F, 245
IEC66 or similar (example RHH or VSN) when you connect the heater to the electricity
network. All cables that are connected in the heater, control panel or the lamp must be of
the same model and dimension.
Connect the electricity
Connect electrical cables
1. Lay the heater down and unscrew the bottom plate.
2. Connect the cable between the control panel and the sauna heater (400V 3N~).
3. Connect the cable between the control panel and the sauna heater (24V). Observe
the colour codes on page 28.
4. Shorten the cables if they are to long.
5. Fasten the bottom plate and lift up the heater.
Electrical scheme for the heater
24 V from control panel
Voltage to the heater from the
control panel (400 V 3N~)
Heating elements
(see the dimensions on page 27)
In
fo
r
m
a
tion
for
the
installer
