18
360113-1
UltraCW™ Automatic Cell Washing System Service Manual
4.4
Removing and installing the front panel
NOTE:
For more information about locating and identifying parts, see Section 5, “Parts”
and
Section 6, “Schematic.”
Several serviceable parts are located behind the front panel. This section explains how to access them.
Bottom view of the front of the cell washer
Cell washer with front panel removed and flipped upward
You will need the following to remove or install the front panel:
►
2.5 mm Allen wrench
To remove the front panel
1
Open the lid, turn off the cell washer, and disconnect it from power.
2
Remove the three screws that secure the bottom of the front panel to the base.
3
Gently pull the bottom of the panel away from the base.
4
Lift the front panel until the groove on the panel disengages from the tongue on the housing.
To install the front panel
1
With the lid open, place the front panel on the front of the housing so that the groove on the panel fits
around the tongue on the housing.
2
Press front panel downward to engage the tongue and groove.
3
Press the bottom of the panel against the base.
4
Slide the front panel sideways until the sides of the panel align with the base and the screw holes align.
5
Install the three screws to secure the panel to the base.
