Helmer Scientific i.Series
®
Ultra-Low Freezer
Service and Maintenance Manual
360173-A/C
10
2.8 Configure Storage
CAUTION
• Use appropriate gloves when handling cold interior components and stored inventory.
• Keep hands away from pinch points when closing the door.
• Before moving shelves, ensure they are empty for safe lifting.
• Maximum shelf load is not to exceed 160 lbs (73 kg).
• Total freezer weight (including contents) is not to exceed 1400 lbs (635 kg).
NOTICE
• Before moving storage components, protect stored items in freezer from extended exposure to adverse temperature.
• When removing or replacing storage racks, do not allow the storage rack to set on the top edge of a partially-open
interior door.
• To avoid damage to the interior door hinges, do not apply upward or downward force to the interior doors.
Product Loading Guidelines
When loading your freezer, take care to observe the following guidelines:
♦
Never load freezer beyond capacity.
♦
Always store items within shelves.
Shelves
Remove Shelf
1. Using both hands, lift the front edge of the shelf off the shelf clips.
2. While holding the shelf at an angle, lift and remove it from the chamber and set aside.
Install Shelf
1. Insert shelf into chamber holding it at an angle.
2. Lower the back edge of the shelf onto the shelf clips in the rear of the unit.
3. Pivot the shelf downward, lowering the front edge onto the shelf clips.
Move Shelf Clips
1. Grip the shelf clip and pivot it upward to disengage the lower tab from the standard.
2. Disengage the upper tab from the standard and remove the clip.
3. Insert the upper tab into a slot in the standard at the desired location.
4. Pivot the shelf clip downward and insert the lower tab into the corresponding slot on the standard.
5. Repeat for each shelf clip until all four clips are at the same level.
Shelves
Shelf clip and
shelf standard
