Helmer Scientific i.Series
®
Ultra-Low Freezer
Operation Manual
360172-A/D
6
2.4
Rear Stand-Offs
CAUTION
The rear stand-offs include a hole to accept a threaded fastener for anchoring the freezer to a wall. The rear stand-offs do not
provide a secure means to anchor the freezer to the wall that can be considered resistant to seismic events.
Notes
• Installation of the rear stand-offs is optional.
•
Anchoring the freezer to the wall is optional.
•
Hardware to anchor the freezer to the wall is not provided with the freezer. The end user is responsible for determining the
best method to anchor the freezer to the wall.
Install Rear Stand-Offs
Rear Stand-off
1.
Align the holes in the stand-offs with the corresponding threaded holes on the back of the freezer.
2.
Insert the 3/8” hex head cap screws through the holes in the stand-offs.
3.
Hand-thread the cap screws into the threaded holes.
4.
Using a 9/16” open-ended wrench, tighten the cap screws.
2.5
AC Power Cord Retainer
NOTICES
•
Do not position the freezer where it will prevent access to the power cord disconnect at the wall receptacle.
•
Use only manufacturer supplied power cord.
Install Power Cord Retainer
1.
Insert the power cord into the receptacle on rear of the cabinet.
2.
Slide the retainer upward, engaging the groove in the power plug with the slot in the retainer.
3.
Align the holes in the retainer with the corresponding holes on the cabinet.
4.
Insert the screws with lock washers through the retainer and into the holes in the cabinet.
5.
Using a #2 Phillips screwdriver, tighten the screws.
Power Cord Retainer
