11
BED CALIBRATION
In order to be able to print, you first need to calibrate the bed.
You need to evenly level the bed so the first layer of the print can adhere well to the bed,
otherwise it may ruin your print.
For this you can use the Pronterface or the LCD.
USING PRONTERFACE
Before starting to level the bed, you can jog the extruder
and the bed using the jog buttons (picture below) on Pronterface.
You can move the Z axis in a way that the nozzle stays a bit closer
to the bed and is essential for the following steps.
Use the 3 screws to level the bed. This is done to give the same clearance from the nozzle on all
points of the bed.
