HELIX HR3500, Инструкция по сборке

Страница: 12 / 28

PAGE 12
11
1
2
3
3
11
10
3
ASSEMBLY INSTRUCTIONS 3
STEP 6:
ASSEMBLE DOME-SHAPED COVER AND RUBBER GASKET
Slide the dome-shaped cover over the upright tube noting that the hole in the dome-shaped cover is positioned closer to one
side. That side should face the rear of the machine, away from the user, as the dome-shaped cover is installed.
Apply only gentle pressure to fit the tabs (shown in Figure #1) in place by squeezing the dome-shaped cover slightly and
sliding the tabs into the holes in the lower plastic housing. Release the gentle pressure to snap the tabs into place. The dome-
shaped cover is shown installed in Figure #2.
Slide the rubber gasket down the center upright tube and push it into place as shown, noting that the slightly V-shaped side
of the gasket faces the rear. See Figure #2 and Figure #3.
HR3500 manual.indd 12 20/09/2017 18:47