HELIX HR3500, Инструкция по сборке

Страница: 13 / 28

PAGE 13
4
3 ASSEMBLY INSTRUCTIONS
(#22) M8x15 Bolt x 4
(#20) M8 Washer x 6
(#23) M8x58 Bolt x 2
(#24) M8 Locknut x 2
(#29) S5 x1
(#32) S10, S13, S14, S17 x 1
20
20
20
20
22
22
23
23
24
24
4
3
5
STEP 7:
ASSEMBLE HANDLEBAR
While holding one handlebar, carefully feed the pulse sensor wire into the upright and out the hole at the top of the upright,
as shown in Figure #4 below.
Once the wire pokes out the top of the upright, use a long bolt to lightly secure the handlebar to the upright. Then thread
the other two bolts #22 into place. Once all the bolts are in place, secure them. Repeat the same process to install the other
handlebar on the other side. Please see Figure #4.
NOTE: FOR EASE OF INSTALLATION, FIRST INSTALL THE LONG BOLT TO HOLD THE HANDLEBARS IN PLACE. THIS
WILL MAKE IT EASIER TO INSTALL THE SHORT BOLT.
HR3500 manual.indd 13 20/09/2017 18:47