3
AssembLy - COnsOLe / COmPuTeR
PAGE 11
Step 10:
Console Bracket Installation: Feed three (3) wires through the center hole of the console bracket as
shown in Figure #1 above. Once the three wires are completely through, install the four (4) bolts
securing the console bracket to the upright (Figure #2).
COMPUTER INSTALLATION
1
2
Slide onto bracket.
Beware not to pinch
the computer wires
Step 12:
Once the wires are all connected, slowly slide the computer onto the mounting plate (Figure #2).
Please be extremely careful not to pinch the wires as the computer slides down onto the bracket. Once
fully slid onto the bracket, install the four computer mounting bolts in the four holes on the back of the
computer (Figure #3).
Do not over tighten. Just make them secure.
Step 11:
Connect the three wires coming out of the computer
mounting plate with the three wires coming out of
the back of the computer. Simply snap the connec-
tors together. The two similar wires/connectors can
be connected with either of the same style on the
back of the computer. It doesn’t matter which goes
to which (Figure #1)
1
2
3
#12
#12
HLT2500.indd 11
04/10/2015 19:09
