Helios ultra Silence MiniVent M1/150 N / C, Инструкция по установке и эксплуатации

Страница: 28 / 56

MiniVent M1/ 150 N / C
EN EN
Installation and Operation Instructions
8
2. Drill holes
Set casing against the wall, mark the holes and drill. Fasten with at least 2 screws and plugs.
3. Back draught shutter and guide vane
- The back draught shutter
ü
(scope of delivery) can be installed behind the guide vane if required (fig.7).
- When installing the device, the guide vane
ö
must be mounted vertically (fig.7).
Snaps into place every 90° rotation.
- Affix the rubber foam (scope of delivery) before final assembly (fig.7)
fig.6
Cable runs under the casing.
â
Break out entry
knockout for cable for
wall mounting
ê
Condensate drain
holes for ceiling sus-
pension
ô
Cable grommet
fig.8
â
ê
ê
ô
fig.5
Ø 150 mm
r=83 mm
min.
130 mm
min. 130 mm
Possible ca-
ble exit area
Drill holes
Recommen-
ded
cable
exit optional
0...-360°,
ideally
in each
case 45°
Guide vane
ö
removable
Back
draught
shutter
ü
removable
ö
Affix the
rubber
foam
m vertical for wall installation
top
bottom
fig.7
