Helios ultra Silence MiniVent M1/150 N / C, Инструкция по установке и эксплуатации

Страница: 24 / 56

MiniVent M1/ 150 N / C
EN EN
Installation and Operation Instructions
4
2.7 Protection against contact
- MiniVent M1/150 N / C mini fans are delivered with an intake-side protection guard as standard. Depending on the moun-
ting conditions, protection against contact may also be required on the discharge side. Corresponding protection guards are
available as accessories.
- Fans which are protected by their installation method (e.g. installation in ventilation ducts or closed assemblies), do not
require protection guards if the plant provides the necessary level of safety. It is noted that the operator is responsible for
adhering to current standards and can be held liable for accidents due to a lack of protective equipment.
2.8 Motor protection device
TheM1/150 N / C MiniVent has an energy-saving, maintenance-free, external EC motor (interference-free, ball bearing-moun-
ted) with the highest efficiency factor. The motor is equipped with a thermo contact, which is wired in series with the winding,
and which automatically switches off and on again after cooling. In case of a blocked rotor, the motor will commence restart
attempts in 3 second intervals.
The motor must be in a certain rotor position in order to start. If it is not in this position, it will send impulses to the rotor in
order to reach this position. This may take a few seconds.
3.0 Technical data
Impeller Ø [mm] 137 Electrical supply line NYM-O 4 x 1.5 mm²
Alternating current 1~ Protection category IP 45 (water jet protection)
Voltage/frequency 230 V, 50 Hz Protection class II
Power consumption [W] 10 / 6 Weight approx. kg 1.2
Rated current [mA] 110 / 90 Speed [1/min] 1900 / 1600
Flow volume [m 3 /h] 260 / 220 Overrun [min.] 6, 10, 15, 21 ( adjustable)
Interval [hrs.] 0, 8, 12, 24 (adjustable)
3.1 Accessories
DSEL 2 Operating/speed switch 0-1-2 Ref.No. 1306 TWH 150 Telescopic wall sleeve Ref.No. 6354
WES 150 Wall installation kit Ref.No. 0537 MBR Mounting cover strip Ref.No. 0281
3.2 Dimensions
CHAPTER 3
TECHNICAL DATA
Dimensions in mm
fig.1