Helion Select Four 10 sc, Руководство пользователя и техническая информация

Страница: 20 / 42

20
Setting the Gear Mesh
1. Loosen the clamping screw securing the motor plate’s rotation in the
motor mount, only enough to allow the motor to rotate in the mount.
Check and ensure there is no debris in the gears affecting the mesh.
2. Rotate the top of the motor away from the center of the chassis, insert
a strip of notebook paper between the pinion and spur gear, then rotate
the motor plate back until there is no backlash. You will have to push/
twist relatively hard to ensure the paper is pressed all the way into the
teeth.
3. Hold the motor snugly in position while retightening the screw. Only
tighten the screw until the motor won’t move. There should be a slight
gap between the coils of the spring.
4. Rotate the spur gear (turn the tires) to feed the paper out of the mesh,
re-check the gear mesh and adjust again if necessary.
5. Re-install the spur gear cover when the mesh is properly set.
WARNING: NEVER OPERATE YOUR VEHICLE WITH THE SPUR GEAR COVER
REMOVED. SEVERE INJURY, DAMAGE TO ELECTRICAL COMPONENTS, AND
EXCESSIVE WEAR AND TEAR ON DRIVETRAIN MAY RESULT.
Shocks
Periodically inspect the shocks for smooth motion, leaking oil and dirt residue
build up around the shaft or caps. Do not allow dirt to build up around the
shock shaft and bottom of the shock. Doing so will reduce the life of the
shock and cause a shock to leak oil. Be sure to clean the shocks regularly
with a clean and dry soft bristle brush and/or rag.
CAUTION: NEVER USE SPRAY CLEANERS TO CLEAN YOUR SHOCKS, DOING SO CAN
CAUSE DAMAGE TO THE SEALS, CAUSING THEM TO LEAK MORE AND REDUCE THE
LIEF AND PERFORMANCE OF YOUR SHOCKS.
Signs to look out for determining if your shock needs to be maintained or
rebuilt.
• Oil around the shaft means the oil leaked from inside and needs to be
replaced.
• Persistent oil around the shock shaft or lower portion of the shock
typically points to damaged O-rings which will need replacing. See your
local hobby dealer for replacement parts.
Refilling your shocks:
1. Remove shock from vehicle, remove spring and top cap. Remove the
bleed screw from the cap.
2. With shock shaft extended, add oil to top of body (use only 100% silicone
oil) and reinstall the shock cap. Be sure the o-ring stays “seated” and
does not squeeze out.
Turn right to tighten
and left to loosen
Clamping
Screw