2 of 3 | 19.10.2016
4. Commissioning
1. Unpack the contents and check to see if they are complete and intact. Immediately contact your retailer
if you notice a defect.
2. Unroll the LED strip from the spindle
3. Clean the surface where you want to attach the LED strip.
4. Fix the strip on the desired position using the provided brackets and screws.
5. Plug together the connection plug of the strip with the connection socket of the driver*.
6. Insert the power pack mains plug* into the power socket.
7. The LED strip can be shortened to your ideal length (each
10 cm) if required. Cut off the strip on the copper
coloured connection using a pair of scissors.
Note:
Please note that after shortening the LED strip the protection type is not provided any longer at this point!
The point of separation must be sealed with silicone/shrink wrap/end cap to achieve the original protection
type again.
If you want to part the strip into pieces and lay several pathways, please note that each connection
has to be injected and soiled separately. Regard the proper sealing!
*Driver is not included and needs to be obtained separately!
5. Faulty Function
LED strip does not switch on
The LED strip has one direction of flow - check the connection of the distributor to the LED strip.
LED strip connected with the power supply?
Remote control does not work.
Battery inserted correctly? Check the poles.
Battery low or defective. Replacing the battery
Sensor within range? Reduce the distance to the sensor.
Connection cable
Soldering joints
Sealing
