www.heinner.com 2500W, 50/60Hz, 220-240V
17
1. Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2. Back castor: Screw off the wing nuts from the U-shaped bolt provided, attach
the U-shaped bolt to the U-facing flange between last two fins. To attach the castor
mounting plate to the radiator body, you should insert the threaded ends of the U
bolt in the holes on the castor mounting plate.
3. Front Castor: Put the castor on the front cover against screws.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5. Repeat 2, 3, and 4 on the rear of radiator for mounting of the rear Castors.
Note: the rear castors must be mounted between the end two fins.
CORD WRAP ASSEMBLY
1. Turn the radiator body in the up direction; take out the two cord wrap mounts
and two screws.
2. Put the two cord wrap mounts as shown in the below photo, and attach with the
included screws.
Note: The function of cord wrap is to store the power cord.
It will not affect the function of the radiator, if you decide not to install the cord
wrap.
