Heinner HEM-1100CR, Инструкция по эксплуатации, Страница: 24 / 60

www.heinner.com 1100W, 50Hz, 220-240V
23
9. You can take the metal funnel out by turning clockwise, then pour the coffee residue
out with the steel mesh pressed by press bar.
10. Let them cool down completely, then rinse under running water.

FOR CAPPUCCINO
You can get a cup of cappuccino by topping a cup of espresso with frothing milk.
Note: during making steam, the metal funnel must be assembled in position.
1.
Prepare espresso first with container big enough according to the part “MAKE ESPRESSO
COFFEE”, and make sure that the steam control knob is at the minimum position.
2. Press down the coffee/steam button to the lower position which is the “ ” position,
waiting for until the ready indicator (green) illuminate.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are
recommended to use whole milk at refrigerator temperature (not hot!).
4. In order to get better milk foam performance, you are recommended to keep steam knob
open position for approx 15s, since the early steam contains too much water. Then keep
the knob in stop and conduct next step.
5. Insert the steam wand into the milk about two centimeters, then turn the steam control
knob slowly in anti-clockwise, steam will come out from the steam wand. Froth milk is
produced by moving vessel round from up to down.
Note: never turn the steam control knob rapidly, as the steam will accumulate rapidly in
short time which may increase the potential of the risk of explosion.
Note: Never touch steam outlet during steam jetting and be careful not to get burnt.
6. When the required purpose is reached, you can turn the steam control knob to the
minimum “0” position.
7. Please follow the operation as below to avoid the steam outlet being blocked after finish
frothing milk each time: put an empty jug under the steam band, then turn on the steam
knob and press down the pump control button “ ” to the lower position, the pump
will pump water, after the water flowing out for 30 seconds, press the pump control
button “ ” to the higher position, finally, clean the steam outlet with wet sponge, but
care not to be burnt!
8.
Press and release the ON/OFF button “ ” to cut off the power source.