Heinner HDU-M20, Инструкция по эксплуатации

Страница: 42 / 101

www.heinner.com
41
Power button
Press to turn the dehumidifier on and off.
Note: The power light illuminates when the unit is switched on and turns dark when the
unit is switched off. When Humidity/Temperature sensor malfunction occurs, the power
light blinks at 5 times per second (on some models).
Continue (CONT) button (on some models)
Select for the dehumidifier to operate continuously for maximum dehumidification until
the bucket is full. The Humdity set control pads cannot be used when Continuous
operation is on. Press this pad again to cancel Continuous operation and enter
dehumidifying mode.
Silent button (On some models)
Control the fan speed. Press to select either High or Low fan speed. Set the fan control
to High for maximum moisture removal. When the humidity has been reduced and
quiet operation is preferred, set the fan control to Low.
Timer button (On some models)
Press to initiate the Auto start or Auto stop feature, in conjuction with the buttons.
When the unit is on, press the Timer button to activate the Auto stop feature. When the
unit is off, press this button to activate the Auto start feature.
Press or hold the and button to change the Auto time by 0.5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours.
The control will count down the time remaining until start.
The selected time will register in 5 seconds and the system will automatically revert
back to display the previous humidity setting.
Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel
the Auto start or Auto stop feature.
When LED display window displays the code of P2, the Auto start or Auto stop feature
will also be cancelled.
UP/DOWN buttons (On some models)
Humidity Set Control buttons
The humidity level can be set within a range of 35% RH (Relative Humidity) to 85%RH
(Relative Humidity) in 5% increments. For drier air, press the button - and set to a lower
percent value (%). For damper air, press the - button and set a higher percent value (%).
TIMER set control buttons
Use the Up/Down buttons to set the Auto start and
Auto stop time from 0.0 to 24.