38
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data
here, refer to the rating plate.
Replace the lamp
The switch of LED lamp is gravity controlled, when the angle dood-opening is bigger
than 30 degrees, light will switch on and switch off when the angle is smaller than 30
degree.
Notice: If LED lamp does not work when the door is open, please be released and check
as below steps:
-
Firstly, loosen screws on the lamp cover
-
Secondly, loosen the screws fixed on the lamp electronics parts
-
Thirdly, check the cable terminals of electronic parts and terminals of
contacting lines for door lamp is loosening or not. Please fix them if they are
not fixed. Then, check the light is on or not. If the lamp is switch on please
install the lamp cover; if not, please further check the electronic part is intact or
not. If necessary, please replace the electronic part to check the lamp is on or
not. If the lamp still does not work, please contact staff of after-sale service for
assistance.
The steps of LED lamp installing: fix the cable terminals of electronic parts and
contacting lines in the door liner; install LED lectronic parts in the door liner and fix on
by screws; install lamp cover on the holder and fix to finish all process.
WARNING!
The illuminating lamps must not be replaced by the user! If the illuminating
lamps is damaged, contact the customer helpline for assistance. This warning is only for
refrigerators that contain illuminating lamps.
