page 37 of 61
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999248 / 28/04/2011
Configuration
Adjustment
1013 mbar
RS-232...
Sensors...
Display...
Autostart
Off
Defaults
Cancel
- - - - - - - - Back - - - - - - - -
In the menu ”Configuration” the device parameters are preselected.
☞
Adjustment
:
Adjustment of the pressure transducer under vacuum and/or at atmospheric pressure,
see also section ”Readjustment the controller”.
Adjustment at atmospheric pressure is carried out at an absolute pressure value between 1060 - 700
mbar and under vacuum at an absolute vacuum value between 0 - 20 mbar. In the range between 20
and 700 mbar no adjustment is possible; ---- mbar is displayed.
☞
RS-232
:
Configuration of the interface, setting of parameters and commands, see section ”Inter
-
face”.
Baud rate can be set to 19200, 9600, 4800 or 2400, parity on ”8-N-1”, ”7-O-1” or ”7-E-1”, Handshake
on ”no”, ”Xon-Xoff” or ”RTS-CTS” and remote on ”On” or ”Off”.
☞
Sensors
:
Selection of the pressure transducer to be controlled (maximum 4 external sensors).
☞
Display
:
Selection of the device parameters ”
Brightness
” between 0 - 100%, ”
Contrast
” between
0 - 100%, ”
Sound
” ”On” or ”Off”, ”
Units
” ”mbar”, ”hPa” or ”Torr”, ”
Language
” ”German”, ”English”,
”French”, ”Italian”, ”Spanish”, ”Turkish”, ”Korean”, ”Chinese”, ”Portuguese”, ”Russian”, ”Polish”,
”Dutch”, ”Japanese”, “Finnish”.
☞
Autostart
:
If ”
Autostart
” is set to ”On” the controller restarts a running process automatically after a
mains failure. If this is unwanted, set Autostart to ”Off”.
Attention:
If
”
Autostart
” is preselected, the process starts immediately after power failure without
pressing any further key. It is the user’s responsibility to ensure that no dangerous status of the sys
-
tem due to the automatic start-up can occur and to provide appropriate safety measures. If neces-
sary, the user has to check
prior to starting the process
if the option ”
Autostart
” is enabled.
☞
Defaults
: If ”
Defaults
” is set to ”Load”, the controller is reset to factory set values. All stored programs
and parameters are deleted.
The screen-shot shows the factory-set values.
Preselections
☞
Use the selection knob to select the parameters.
5.8 Function Configuration
