Assembly
38
Shaft guard
To prevent injuries caused by rotating parts of the impeller a shaft guard can be
attached. (optional accessory, see section “Accessories”)
Attach shaft guard
➜
Hold the adaptor to the chuck with the
cut-out below the ON/OFFswitch.
Cut-out
ON/OFF switch
✓
Connect the two guide aids to the
holes left and right to ensure correct
fitting.
Guide aids
Cut-out
➜
Attach the adaptor with the two allen
screws and key supplied to the bottom
side of the housing and tighten them
until it stops.
Allen
screw
and key
➜
Attach both knurled screws to the drill
hole on the adaptor and tighten them
with 2 - 3 turns.
➜
Push the grooves on the shaft guard
alongside the knurled screws until the
screws reach the end of the groove.
Now turn them clockwise to the end of
the groove.
➜
Tighten both knurled screws to hold
the shaft guard firmly in place.
Shaft guard
Knurled screws
Remove shaft guard
➜
Untighten both knurled screws holding the shaft guard to the adaptor with 1 - 2
turns.
➜
Turn the shaft guard slightly left and remove it from the stirrer.
