hecht 9534 SQ, Оригинальное руководство пользователя

Страница: 23 / 44

23 / 44
PL
SK
CS
EN
• Dangers caused by tearing (of the chain) during running.
• Dangers caused by shooting up of subjects or splashing of liquids.
ELECTRICAL REQUIREMENTS
• Connect the device only on the plug with a protective device to prevent stray current (FI switch)
with a rated fault current of not more than 30 mA.
• Only connect the equipment to a properly grounded outlet with the specified voltage 230V/50Hz
and fuse protection.
• Always use an extension cable with a cross section that corresponds with the power input of
device and the cable length.
• Cable drum before using completely unwind. Make sure the cord is not damaged.
Caution! Do not touch the damaged cable and pull the mains plug when the cable
is damaged while working. Damaged cables increase the risk of an electric shock.
If the power supply is damaged, it must be immediately replaced with a cable
without defect, to avoid dangerous situations.
Note: In case of doubt, check with your electricity supplier or with your electrician
if your home connection meets these requirements.
UNPACKING
• Carefully remove the product from the box.
• Carefully inspect all parts. If any part is damaged or missing, contact your dealer or authorized
service center.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger.
• Disposal must be made in accordance with the regulations in force in the country in which the
equipment was installed.
• Make sure that bags and containers of plastic material are left strewn freely in the environment
because they pollute it.
• If you have any doubt do not use the machine, but have it checked by an authorized service
center.
PACKING.LIST:.
1x machine body, 1x handle, 1x chute, 1x manual for use
ASSEMBLY
1. Unscrew the bolt(fig. 2) and carry away the upper bracket.
2. Mount the armrest (fig. 3A): first unscrew the nut (fig. 4), put in order four bores on the
upper armrest, plug in the bolt and screw it with a nut.
3. Mount the connecting rod: pull out pinchcock (fig. 5A) and pin bearing, drill through a bore
on the connecting rod (fig. 5B) with a pin bearing, plug and fix the pinchcock in the pin
bearing, and screw the other side on the connecting rod (fig. 6A) with a nut.
4. Mount the chute: first unscrew the chute on the bolt, place it on the chute seat (fig. 7), put