4.
TECHNICAL CHARACTERISTICS
5.
FAQs
Description:
STEEL 800 W
Measures:
450 x 450 x 50 (mm)
Weight:
5.5 Kg.
Description:
STEEL 1500 W - 2000 W
Measures:
900 x 450 x 50 (mm)
Weight:
10.20 Kg.
Description:
STEEL 800 W VERTICAL
Measures:
450 x 900 x 50 (mm)
Weight:
10.20 Kg.
Description:
CLASSIC 800 W
Measures:
500 x 1000 x 70 (mm)
Weight:
10.35 Kg.
Description:
CLASSIC 1500 W - 2000 W
Measures:
1000 x 500 x 70 (mm)
Weight:
20,20 Kg.
Description:
CLASSIC 800 W VERTICAL
Measures:
500 x 1000 x 70 (mm)
Weight:
20,20 Kg.
Voltage:
203 V
Frequency:
50 Hz
Plug:
Bipolar 10-15 A/250 VAC
Safety Thermostat:
Automatic – Cut-off Tª 90 ± 0,5º - Reset Tª 65º ± 10º
Electronic Thermostat:
Temperature Oscillation from 17-24ºC
Type of Protection:
Class II IP 24
Back Frame
High-quality Steel
Front STEEL
White Satin Steel RAL 9001
Front CLASSIC
DUAL KHERR
MEASURES & WEIGHT
TECHNICAL CHARACTERISTICS
MATERIALS
PROBLEM
PROBABLE CAUSE
SOLUTION
Incorrect setting of the set temperature
Check the set temperature on the display to verify it is the desired temperature.
Improper sizing
The power is not the adequate for the place in which it has been installed.
Excessive height
Make sure the system is installed at the recommended height
Input and output grids are obstructed
Do not place anything on top of the radiator and do not install it inside a hole made in
the septum.
Set temperature below room temperature
Rise the radiator’s set temperature until it is 1 degree above the room temperature
Check that the automatic control is not down. If it is down put it up.
Make sure the installation is correct and that there are independent lines for the
heating system with a 2.5 mm2 cable gauge and a maximum power of 3500 w.
Switch is off
Set the switch in position I.
Program is OFF
Check that the set program is the chosen one or set the one you desire.
Radiator located at a very low height
The minimum height from the floor to the radiator’s lower part must be at least 25
cm.
Dust accumulation in the lower grid.
Vacuum it. The vacuuming should be done at the beginning of each heating season.
Type of painting on the wall
Paints with a high content in rutile are likely to darken.
Blocked
buttons
No response from operating buttons
Press buttons ON and TIMER for 3 seconds.
Due to the thermal inertia, the device transfers heat to the room; should you need
more temperature, increase the device temperature.
The room
does not reach
the desired
temperature
The radiator
does not
operate
Control panel switch and protection down
The radiator
stains the
walls
The device
does not heat
up
The device is in energy-saving mode
