HeatStar ERSP-100, Инструкция по эксплуатации и руководство пользователя

Страница: 11 / 84

E-11
Operating Instructions and Owner’s Manual Enerco | Heatstar ERSP Series Heater
Couplings:
Tube and tube fittings are connected by wrap-around
couplings which clamp by means of a tapered,
hammer-driven lock member. The starting ends of
the coupling and lock member are identified by 1/4”
holes which are put together when starting assembly.
Be sure the tube ends are in line and tube ends butt
against stop pin(s) inside coupling. The slide bar is to
be hammer-driven to a point of securing the coupling
snugly to the tubes. Over-driving will result in distortion
of the coupling or slide bar lip to a point decreasing
the holding the capability of the coupling.
(See Figure 4)
Elbow Fitting Dimensions
FIGURE 5: Installation of Elbow & Coupling
Elbow Package: Stk. # F106415 Elbow Package includes:
(1) elbow, (1) coupling. Install elbow
into radiant tube sequence where plans
indicate a 90° bend (see Figure 4).
U-T ube Fitting Dimensions 1 80° U-T ube
Stk. # i ncludes: F10641 4 U-T ube Package
COUPLING ASSEMBLY
Plain Coupling - 14612
Key for Coupling - 14616
Tighten
Loosen
Hole 1
Coupling
Assembly
Impact
Block
Hole 2
When assembling coupling note
the location of Hole 1 and Hole 2
Orient coupling so that
the impact block is above
tube centerline.
TUBE COUPLING
KEY for COUPLING
FIGURE 4:
(38.73 CM)
(15.24 CM)
18"
(45cm)
10"
(25cm)
(10cm)
(43cm)
9"
(22cm)
Radius
90
°
(1) U-tube, (1) coupling
Install U-tube elbow into
radiant tube sequence where
plans indicate a 180
0
bend
(see Figure 4)
(22 cm)