Heatmiser NeoAir V2-M, Руководство пользователя

Страница: 11 / 48

10
Air
-M
neo
Pairing with the UH8-RF Wiring Centre
Remove the cover from the UH8-RF.
The current channel number is set inside on the two dials, these
dials are at the top of the circuit board and look like this
(You need to set a unique channel number for each UH8-RF)
On the neoAir:
• Use the Left arrow key to highlight on the menu ...............................................................
• Press and hold for 3 seconds
.............................................................................................................
• SETUP is now highlighted, press once to access the setup menu................................
• The display will show the number 01 in the top right hand corner.
• Press the Down arrow key twice, P2 is displayed
in the top right corner.............................
• Press once .....................................................................................................................................................
Channel Number
(TENS) (UNITS)
Zone Number
01- 08
Zone Type
rA = Radiators
UF = Under Floor
Heating
UH8-RF
Channel Number
01- 99
5
0
4
3
2 1
67
8
9
5
0
4
3
2 1
67
8
9
To control heating only, configure the neoAir in mode 1.
To control heating & hot water, configure the neoAir in mode 3. (See page 7)
Example showing
Channel No. 01