14
35048 Rev L
03/04
IB75 B-VENT GAS APPLIANCE
I. LIGHTING INSTRUCTIONS
Intermittent Pilot Ignition
FOR YOUR SAFETY
READ BEFORE OPERATING
INTERMITTENT PILOT IGNITION LIGHTING INSTRUCTIONS
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, per-
sonal injury or loss of life.
A.
This appliance is equipped with an ignition device which automatically lights the pilot.
Do not
try to light the
pilot by hand.
B. BEFORE LIGHTING
smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbors phone. Follow the suppliers instructions.
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to close the gas line. Never use tools. If the knob will not push in or turn by hand, dont try
to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which as been under
water.
TO TURN OFF THE GAS TO THE APPLIANCE
1.
Turn wall switch to the OFF position.
2.
This appliance is equipped with an ignition device which automatically lights the pilot.
Do not
try to light the pilot
by hand.
3.
Wait five minutes to clear out any gas. If you then smell gas, STOP! Follow B in the safety information above
on this label. If you do not smell gas, go on to the next step.
4.
Turn the wall switch to the ON position.
5.
If the appliance will not operate, follow the instructions TO TURN OFF THE GAS TO THE APPLIANCE and
call your service technician or gas supplier.
6.
If using the battery pack and the appliance will not operate, check the batteries for sufficient charge and replace
if necessary.
1.
Turn off the wall switch.
2.
Open control access panel. Turn manual shutoff
valve to the CLOSED position. Do NOT force.
3.
Close control access panel.