17
Heatilator • ECLIPSE-32, ECLIPSE-36 Owner’s Manual • 2297-985 Rev. C • 4/15
5
5
Frequently Asked Questions and Troubleshooting
A. Frequently Asked Questions
ISSUE
SOLUTIONS
Condensation on the glass
This is a result of gas combustion and temperature variations. As the
fi
replace warms, this
condensation will disappear.
Blue
fl
ames
This is a result of normal operation and the
fl
ames will begin to yellow as the
fi
replace is al-
lowed to burn for 20 to 40 minutes.
Odor from
fi
replace
When
fi
rst operated, this
fi
replace may release an odor for the
fi
rst several hours. This is caused
by the curing of the paint and the burning off of any oils remaining from manufacturing. Odor may
also be released from
fi
nishing materials and adhesives used around the
fi
replace.
Film on the glass
This is a normal result of the curing process of the paint. Glass should be cleaned within 3
to 4 hours of initial burning to remove deposits left by oils from the manufacturing process. A
non-abrasive cleaner such as gas
fi
replace glass cleaner may be necessary. See your dealer.
Metallic noise
Noise is caused by metal expanding and contracting as it heats up and cools down, similar to
the sound produced by a furnace or heating duct. This noise does not affect the operation or
longevity of the
fi
replace.
Is it normal to see the pilot
fl
ame burn
continually?
In an intermittent pilot ignition system (IPI), the pilot
fl
ame should turn off when appliance is
turned off. Some optional control systems available with IPI models may allow pilot
fl
ame to
remain lit.
Lava Rock/Optional Rock Media Kit
There may be some “cracking” noise coming from the
fi
replace during the
fi
rst few heating
and cooling cycles. This noise is associated with settling rock and some minor cracking of
larger pieces of rock. This will lessen over time as the glass rock is conditioned to the heat-
ing and cooling temperature changes.
It is expected that a few small pieces (approximately 10 pieces) of rock may fall through the
base pan and come to rest on the
fi
replace bottom. This has no affect on
fi
replace perfor-
mance.
Power Outages
(battery backup)
This appliance can be operated on battery power in the event of a power outage. To access
the battery pack, the decorative front, mesh and glass assembly must be removed. Refer to
Section 3 for more details.
Contact your dealer
for additional information regarding operation and troubleshooting. Visit www.heatilator.com to
locate a dealer.
