Heatilator • ECLIPSE-32, ECLIPSE-36 Owner’s Manual • 2297-985 Rev. C • 4/15
12
G. Appliance Break-In
Initial Break-in Procedure
• The fireplace should be run three to four hours
continuously on high.
• Turn the
fi
replace off and allow it to completely cool.
• Remove
fi
xed glass assembly. See Section 4.
• Clean
fi
xed glass assembly. See Section 4.
• Replace the
fi
xed glass assembly and run continuously
on high an additional 12 hours.
This cures the materials used to manufacture the
fi
re-
place.
NOTICE! Open windows for air circulation during
fi
re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
H. Heat Management
Heat Output
The ECLIPSE-32 and ECLIPSE-36 models have a
variable burn rate which is controlled by the HI/LO knob
on the gas valve. Therefore the
fl
ame height is adjustable.
The HI/LO knob is shown in Figure 3.4. It is located in the
control cavity of the appliance. The HI/LO knob may be
adjusted as desired by turning counterclockwise to the
HIGH position and by turning clockwise to the LO position.
If an optional fan is installed, the fan speed is controlled
by adjusting the speed control knob. Turn the knob
clockwise to increase the fan speed and counterclockwise
to decrease the fan speed.
CONTROL
CAVITY
VALVE
LOCATION
Figure 3.4 Control Cavity/Valve Location
