Page 3
598-1038-02
SPECIFICATIONS
Range . . . . . . . . . . . . . . Up to 70 ft. (21 m); 100
ft.(30.5 m) with Range Boost.
[varies with surrounding
temperature]
Sensing Angle . . . . . . . . Up to 240
°
Electrical Load . . . . . . . . 200 watt Incandescent (100
Max each lamp holder.)
Power Requirements . . . 120 VAC, 60 Hz
Operating Modes . . . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . . . 1 , 5, 20 minutes
Dual Brite™ Timer . . . . . 3, 6 hours, Dusk-to-Dawn
Replacement lamp . . . . T4 100W, G8 halogen bi-pin
120 VAC
Heath
®
/Zenith reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
❒
Loosen the clamp screw in
the sensor ball joint and gen-
tly rotate the sensor.
❒
Walk through the coverage
area noting where you are
when the lights turn on. Move
the sensor head up, down, or
sideways to change the cov-
erage area. Keep the sen-
sor at least 2" (51 mm) away
from the lamps.
❒
Adjust the RANGE as needed.
Too much range may increase
false triggering. Range Boost
increases coverage up to
100 feet.
❒
Secure the sensor head's aim
by tightening the clamp screw.
Do not overtighten the
screw.
❒
Set the amount of TIME you want the lights to stay
on after motion is detected (1, 5 or 20 minutes).
❒
Set the DUAL BRITE™ switch to the amount of
time after dusk you want the lights on at low level
(Off, 3, 6 Hrs., Dusk-to-Dawn).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Maximum
Range
240
°
Maximum
Coverage Angle
Avoid aiming the sensor at:
•
Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
•
Areas where pets or traffic may trigger the control.
•
Nearby large, light-colored objects reflecting
light may trigger the shut-off feature. Do not point
other lights at the sensor.
The control is most sensitive to motion across it.
Least Sensitive
Most Sensitive
Motion
Sensor
Motion
TEST AND ADJUSTMENT
❒
Turn on the circuit breaker and light switch.
NOTE:
Sensor has a
1
1
/
2
minute warm up period
before it will detect motion. When first turned on
or when switching modes wait
1
1
/
2
minutes.
Bottom of Sensor
❒
Turn the RANGE control to the mid position, Dual
Brite™ to OFF and the ON-TIME control to the
TEST position.
70 ft.
100 ft.
(21 m) (30.5 m)
Boosted
8 ft.
(2.4 m)
