FOIL
PICTORIAL 2-8
NOTE: If you are using any non-Heath circuit boards
in your Computer, be sure to check these boards to
make sure bus line 18 is not connected to anything.
( ) Carefully unplug the Hl7 controller circuit
board from your Computer.
( ) Cut a 3-1/2" green wire. Then remove 1/4" of
insulation from each end.
( ) Position the controller circuit board as shown
in Pictorial 2-8. Then solder one end of the
3-1/2" green wire to the foil at pin 32 of socket
S103 on your controller circuit board. Connect
the other end of the wire to the foil at pin 18 of
socket S102 on your controller circuit board.
( ) Reinstall the tie bracket and top cover on your
Computer.
Method #2
( ) Remove the tie bracket from your Computer.
( ) Carefully unplug the Hl7 controller circuit
board from your Computer.
