HAE 100 4K
•
Setup Guide
The Extron HAE 100 4K is an audio de-embedder that extracts the audio from an HDMI signal, including audio from 4K sources.
The HAE 100 4K provides an analog output for stereo or dual mono signals, as well as a S/PDIF digital audio output that supports
two-channel or digital multi-channel signals.
Mounting
The HAE 100 4K can be placed on a desktop or tabletop using the included rubber feet, or mounted to a rack or furniture (see the
HAE 100 4K User Guide
, available at
www.extron.com
, for mounting options and instructions).
Cabling
Rear Panel Features and Cabling
SIGNAL
IN OUT
CONFIG
HDCP
AUDIO IN
2-CH LPCM
BITSTREAM
HAE 100 4K
HAE 100 4K
12V
0.6A MAX
POWER
INPUT
OUTPUT
AUDIO OUTPUTS
S/PDIF
ANALOG
L
R
B
B
E
E
C
C
A
A
D
D
A
A
B
B
D
D
C
C
Figure 1.
HAE 100 4K Rear Panel
A
Power input
— Connect the provided power supply to the 3.5 mm, 2-pole captive
screw power receptacle (see the image at right).
ATTENTION:
•
Do not connect the power supply before reading the Attention in the
Power Supply section of the
HAE 100 4K User Guide
.
•
Ne branchez pas la source d’alimentation externes avant d’avoir lu
les mises en garde dans la section « Power Supply » du
HAE 100 4K
User Guide
.
B
HDMI input
— Connect an HDMI input source into this female HDMI type A connector.
NOTE:
By default, the EDID stored at the HDMI input is set to 720p at 60 Hz with 2-channel audio. EDID can be
configured using Extron PCS software or SIS commands (see
Configuration
on the next page).
C
HDMI output
— Connect an HDMI output device into this female HDMI type A connector.
NOTE:
It is not required to connect an HDMI output device to extract audio from the HDMI input device.
D
S/PDIF audio output
— Connect a S/PDIF audio output device into this female RCA connector. This connector outputs
digital S/PDIF audio formats (2-channel LPCM, Dolby Digital, or DTS).
NOTE:
By default, the audio input format is configured for 2-channel audio. In this configuration, the S/PDIF and
Analog outputs are active, but only 2-channel audio will pass. The audio setting can be configured using PCS or
SIS commands
(see
Configuration
on the next page).
E
Analog audio output
— Connect an audio output device to this 5-pole 3.5 mm captive screw connector (see figure 2 below
for connector wiring).
NOTE:
By default, this output is configured for stereo audio.
It can be configured for dual mono audio
using PCS or
SIS commands
(see
Configuration
on the next page).
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 2.
Analog Output Connector Wiring
SECTION A–A
A
A
Power Supply
Output Cord
Captive Screw
Connector
Ridges
Smooth
3/16"
(5 mm) Max.
