4
204055-02
RANGE
10 5 1 TEST
ON-TIME
MIN MAX
Light Shield Installation
If your light does not come on at dusk or turns off un-
expectedly, then another light source may be activating
the daytime shutoff feature. Possible sources of light
interference are street lights, landscape lighting, other
security lights or lanterns, or an interior house light shin-
ing through a window. It could also be reflective light,
such as from a pool or light colored wall.
To install the light shield, follow these simple steps.
1. Remove protective backing from the bottom of the
light shield.
2. Position light shield over the photocell with the
opening facing away from the interfering light.
3. Press the adhesive side firmly against the photocell
to mount it permanently in place.
TEST AND ADJUSTMENT
1.
Turn on the circuit breaker and light switch.
NOTE: Sensor has about 1
1
/
2
minutes warm up period
before it will detect motion. When first turned
on, wait about 1
1
/
2
minutes.
2. Turn the RANGE control to the minimum posi-
tion (MIN) and the ON-TIME control to the TEST
position.
Avoid aiming the control at:
• Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sources could cause false triggering.
• Areas where
pets or traffic may trigger the control.
•
Nearby large, light-colored objects reflecting light
may trigger the shut-off feature. Do not point other
lights at the sensor.
Bottom of Sensor
Maximum Range
Maximum
Coverage Angle
70 ft.
(21 m)
8 ft.
(2.4 m)
Least Sensitive
Most Sensitive
NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming
the sensor down will reduce coverage distance.
The detector is most sensitive to motion across its field
of view.
1. Loosen the clamp screw in the
sensor ball joint and gently
rotate the sensor.
2. Walk through the coverage
area noting where you are
when the lights turn on (also,
the LED will flash several times
when motion is detected). Move
the sensor head up, down, or
sideways to change the cover-
age area.
Keep the sensor at
least 1" (2.5 cm) away from
the lamp.
3. Adjust the RANGE as needed.
RANGE set too high may
increase false triggering.
4.
Secure the sensor head
by tightening the clamp
screw. Do not overtighten
the screw.
5. Set the amount of TIME you want the lights to stay
on after motion is detected (1, 5, or 10 minutes).
180°
Motion
Motion
Sensor
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
WARNING - Risk of fire. Do not aim the bulbs
at a combustible surface within 3 ft. (1 m).
