55
Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. T • 3 /14
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modifi cation of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
• Read, understand and follow these instructions for safe
installation and operation.
Kit Contents
REM300-HNG-AU
• REM300-HNG-AU Transmitter
• AAA Batteries (3)
• Wall Holder
• Drywall Anchor (2)
• Screws (2)
Introduction
The RC300AU multifunctional remote control is designed
to control pilot light, fl ame height, blower speed, and up
to two 220/240 VAC auxiliary functions on your gas fi re-
place. The RC300AU is equipped with thermostat func-
tions which can automatically control the temperature in
the room in which it is installed. The control is only for use
with the Hearth & Home Technologies IntelliFire Plus™
system (IPI). The AUX300CE module is rated for 220/240
VAC, 50-60 Hz, and is required for operation of this remote
control device.
Installation Precautions
The installation of this remote control must be performed by
a qualifi ed service technician. This remote control is tested
and safe when installed in accordance with this installation
manual. Do not install any components that may be dam-
aged.
Do not modify, disassemble, or substitute any of the compo-
nents included with this kit. Installation of this unit must be
done by a qualifi ed service technician.
Placement of this remote control may affect performance. An
assessment of the space should be done prior to installation
for optimum performance.
Determine Location
Determine the location for the remote control. The selected
location should be in the same space as the gas fi replace.
Never place this unit in a separate room. The remote control
must be placed within 30 ft. (9.14 m) of the fi replace but should
not be exposed to extreme heat.
The RC300AU is approved for interior installation and should
not be used in exterior applications.
• Keep remote control out of reach of children.
Fireplace Specifi c Information
Standard fi replace features vary. Consult the installation
manual for available options.
The included
AUX300CE
receiver provides additional fea-
tures: Fan control and two Aux functions.
The
REM300-HNG-AU
remote control system functions
include: On/Off, Thermostat Mode, Timer Countdown,
and Flame Adjustment (for fi replaces with variable fl ame).
BLUE
BROWN
GREEN/
YELLOW
Figure 12.2
D. Blower
These heaters have a factory installed fan and electrical
junction cord. These components are located behind the
lower door.
Use of the fan requires that the Junction cord (factory in-
stalled) be connected to 220/240 VAC service before per-
manently enclosing the heater. The service cord is found
on the right exterior side of the unit. See Figure 12.2 for
wire connection detail.
240V BLOWER
JUNCTION CORD
AUX 300 CE
GROUND TERMINAL TO
FIREPLACE CHASSIS
E. Control Module Operation
See Section 2.J for Control Module Operation.
