OPERATIONS & CONTROLS
WASHABLE LIFETIME FILTER SYSTEM
Heat Storm™ Infrared Heaters come equipped with a washable lifetime filter which is easy
to clean. (The manufacturer recommends the filter to be cleaned regularly as needed.) To
do this, follow these steps:
● Press both tabs to remove the filter cover and remove the filter, noting which side of
the filter receives air flow into the heater.
● Run warm tap water over the filter, the opposite direction of air flow, until water runs
clear. The filter might excrete some filtered residue, so be cautious not to drip on any
stain-able surfaces such as carpeting. You can also soak the filter in water mixed with
a small amount of mild dish soap (remember to rinse well with clean water after
soaking filter).
● Shake the filter over a sink until excess water is removed and allow it to drip dry
completely before reinstalling.
● DO NOT force or attempt to speed the filter drying process by using any
alternative methods.
● ENSURE that the filter is completely dry before inserting back into the air inlet and
replacing covers.
● Reinstall the filter and replace cover.
WARNING
ANY REQUIRED SERVICE OTHER THAN FILTER MAINTENANCE SHOULD ONLY BE PERFORMED
BY AN AUTHORIZED SERVICE REPRESENTATIVE
11
10
OPERATIONS & CONTROLS
SETTING TEMPERATURE
● When pressing either the up or down buttons the display will enter temperature setting
mode. The heater will indicate that it is in temperature setting mode when the
numbers begin to blink.
● When in temperature setting mode, pressing the up and down buttons will change the
thermostat by 1 °F or by 1 °C.
● The default set temperature of the heater is 72° F (22° C).
● After 5 seconds without control input the display will exit temperature setting mode
and show the current ambient temperature.
NOTE: After the heater function or power is shutoff the blower will continue to run for
several minutes to cool the internal components.
CHILD LOCK FEATURE
● Press the On/Off button for 5 seconds to engage child lock.
NOTE: Setting the child lock feature can only be performed using the
Control Panel on the heater and is not available using the remote control.
THERMOSTAT CALIBRATION
Thermostat readings can vary based on the environment. If desired, the thermostat on the
heater can be manually calibrated to match central HVAC system.
NOTE: Thermostat calibration can only be performed using the Control Panel on the heater
and is not available using the remote control.
NOTE: Typically Heat Storm Infrared Heater thermostats are more accurate than home
central thermostats. Changing your Heat Storm Infrared Heater to match your central
system may reduce its efficiency.
1. Press the On/Off button and hold all three buttons down for 10 seconds to
begin calibration.
2. Use the up and/or down buttons to adjust the thermostat.
3. After 5 seconds without control input the heater will exit thermostat calibration.
