28
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing em-
ber material.
To place the ember material:
•
Remove the wing nuts and glass clips or tension springs
around the glass door.
•
Remove the glass door from the unit.
•
Remove the grate and log set by removing the screws.
•
Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do
NOT
press
embers into burner ports. Cover the top of the burner
with a single layer of ember material. For best perfor-
mance do NOT place embers on the ports at the rear
of the burner.
•
Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is suffi-
cient for 3 to 5 applications.
•
Replace the glass door and a front trim door on the
unit.
Figure 32. Placement of the Ember Material
Optional Ember Light Kit (Emberkit-MS)
Ember Light Bulb Replacement
In the lower gas valve compartment you will find three ac-
cess panels for the three light bulbs (see Figure 33).
Figure 33.
Using a 5/16” nut driver remove the two bolts (see
Figure 34).
Figure 34
Pull the access panel to expose the light bulb. Wear clean
cotton gloves when touching the bulb. Any skin oils which
get on a new bulb will greatly shorten the life of the bulb.
The bulb can be cleaned with isopropyl alcohol (see Figure 35).
Figure 35.
ACCESS PANEL
ACCESS PANEL