Heat-N-Glo LifeStyle Collection • Dakota 42, Dakota 42H • 4036-905 Rev. F • 11/04
4
B. Glass Specifications
Hearth & Home Technologies appliances manufactured with
tempered glass may be installed in hazardous locations
such as bathtub enclosures as defined by the Consumer
Product Safety Commission (CPSC). The tempered glass
has been tested and certified to the requirements of
ANSI
Z97.1
and
CPSC 16 CFR 1202
(Safety Glazing Certification
Council
SGCC# 1595
and
1597
. Architectural Testing, Inc.
Reports
02-31919.01
and
02-31917.01
).
This statement is in compliance with
CPSC 16 CFR Section
1201.5
“Certification and labeling requirements” which refers
to
15
U.S. Code
(USC) 2063
stating “…Such certificate
shall accompany the product or shall otherwise be furnished
to any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass
with permanent marking in such locations. Glass meeting
this requirement is available from the factory. Please contact
your dealer or distributor to order.
A. Appliance Certification
NOTE:
This installation must conform with local codes. In the
absence of local codes you must comply with the
National
Fuel Gas Code, ANSI Z223.1-latest edition
in the U.S.A.
and the
CAN/CGA B149 Installation Codes
in Canada.
Listing and Code Approvals
D. High Altitude Installations
U.L. Listed gas appliances are tested and approved without
requiring changes for elevations from 0 to 2000 feet in the
U.S.A. and Canada.
When installing this appliance at an elevation above 2000
feet, it may be necessary to decrease the input rating by
changing the existing burner orifice to a smaller size. Input
rate should be reduced by 4% for each 1000 feet above a
2000 foot elevation in the U.S.A., or 10% for elevations
between 2000 and 4500 feet in Canada. If the heating value
of the gas has been reduced, these rules do not apply. To
identify the proper orifice size, check with the local gas
utility.
If installing this appliance at an elevation above 4500 feet
(in Canada), check with local authorities.
C. BTU Specifications
1
MODEL:
Dakota 42, Dakota 42H
TYPE:
Vented Gas Fireplace
STANDARD:
ANSI Z21.50-2000•CSA2.22-M00
LABORATORY:
Underwriters Laboratories, Inc. (UL)
Models
Maximum
Input BTUH
Orifice Size
(DMS)
Dakota 42 (NG)
61,000
25
Dakota 42 (LP)
52,000
44
WARNING
Do NOT use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control
system and any gas control which has been under water.
This product is listed to ANSI standards for “Vented Gas
Fireplaces” and applicable sections of “Gas Burning Heat-
ing Appliances for Manufactured Homes and Recreational
Vehicles”, and “Gas Fired Appliances for Use at High Alti-
tudes”.