HearthStone 8410, Руководство пользователя

Страница: 12 / 56

Hearthstone Quality Home Heating Products, Inc ® WFP-75 Model 8410 8
B. Fans operating (e.g.: range hood)
These fans draw air out of the house and may actually cause a negative pressure in the
house. Turn off all fans and open a nearby window to determine if this is the cause of the
problem.
C. Wet wood
Wet or tarred wood will smoulder and smoke instead of burning properly.
D. Dirty or blocked chimney
Check to make sure the chimney is clear and clean.
E. Chimney not long enough
The minimum system height is 15 feet (4.6m). The chimney must extend at least 3 feet (915
mm) above its point of contact with the roof and at least 2 feet (0.6 m) higher than any roof
or wall within 10 feet (3 m) of it. When installed with offsets, the minimum system height is
15 feet (4.6 m) to 17 feet (5.2 m) as per Table 1. Additional height will increase draft and will
decrease the tendency to smoke. If only the minimum chimney height is installed, operating
conditions must be optimal (interior chimney, minimum height of 18” before any offset, etc.).
F. Poor chimney draft
With no fire, there should be sufficient draft to exhaust cigarette smoke introduced under the
baffle. Chimneys installed against an outside wall without protection may generate back draft
problems which will cause start-up problems. To prevent this, open a nearby window, roll
up a piece of paper and light it. Then, hold it in the upper part of the firebox to warm up the
chimney. Wait until the draft is sufficient, then start the fire.
IMPORTANT NOTES
1. Do not block the hot air vents to the fireplace as this will cause the fireplace to
overheat.
2. Never start a fire using gasoline, kerosene, charcoal lighter fluid or any other
combustible liquid.
3. Do not burn coal. The sulphur in coal will corrode the firebox and damage the glass.
4. Do not burn driftwood which has been in the ocean or salt water. The salt will
corrode the firebox and chimney.
5. Do not abuse the unit by burning paper, or cardboard or construction material such
as pressed wood, plywood or lumber.
6. Do not allow the wood to smoulder or burn without flame, since this will
produce excessive creosote in the unit.